2007Operating forum
Ultra2 center button programming and remote side-to-side control troubleshooting
19 years old. Gear and prices may have changed since.
What the thread found
- The center button on the Ultra2 can be programmed like remote buttons to set the stage to center position in both directions or selectively in one direction only.
- Programming the side-to-side center position off-center allows operators to center only the fore-aft axis when the camera naturally balances to one side, useful for quick daily setup after lens or accessory changes.
- When remote side-to-side buttons stop functioning while fore-aft and preset buttons work normally, check the side-to-side direction selector switch on the electronics module to ensure it is not in the center off position.
- The side-to-side control potentiometer on the electronics module in front of the stage can be accidentally adjusted downward, disabling side-to-side remote control.
- Remote battery depletion or poor transmitter button contact from dust can cause remote control failures.
- The Ultra2 system is designed to be user serviceable for troubleshooting common issues without factory support.
Depends on
- Discussion centers on the Ultra2 model specifically.
- Remote control troubleshooting advice is based on user experience rather than comprehensive technical documentation.
- The side-to-side switch issue resolution came from one operator's experience and may not apply to all control failures.