Mounting options and balance considerations for Cinetronic monitors on camera stabilizer sleds

Gear

ZephyrCan I fly my Alexa or RED on a Zephyr?389

Master SeriesIs a used Master Series rig worth buying as a first big rig?191

BFDHow do I power my BFD receiver from my camera or sled?186

VoltCan I retrofit a Volt onto my existing sled or gimbal?168

ArtemisHow do I power my camera and accessories from an Artemis sled?166

MDRWhere can I mount my Preston MDR on my rig?143

ModulusIs there a Modulus option for HD wireless video?141

G-70Will my G-70 fit my vest, gimbal or sled?126

FI+ZCan I control iris and zoom wirelessly, not just focus?60

HU3Where can I get my HU3 repaired, refurbished or repainted?60

CineLiveHow do I pack and case my CineLive rig for transport?54

G-70XHow does the G-70X compare to Pro Titan, Xarm and other arms?46

Trinity 2Is Trinity 2 SUP 3.0 firmware safe to install or buggy?46

Ultra VestWhich vest should I choose for my body size, comfort and operator type?39

2011Monitors forum

15 years old. Gear and prices may have changed since.

The Cinetronic monitor mount is designed to position the screen at a low height, level with battery masses to maintain balanced sled weight distribution.
Using a Cinetronic monitor with only two batteries on the sled bottom and an Anton Bauer HC battery clipped to the back of the monitor can achieve good balance on newer stabilizer models.
MK-V bracket mounting results in higher monitor placement compared to XCS mount positioning on the same sled.
Mounting the monitor higher than its design intent causes imbalanced sled weight distribution due to loss of mass below the screen compared to traditional CRT monitors.

Advice based on specific sled models and battery configurations from 2011.
Limited photographic documentation of various mounting configurations mentioned.
Sachtler telescopic mount vibration performance discussed but not conclusively tested by users in this thread.