What the thread found

• Connecting 12V batteries in parallel eliminates the ability to use 24V mode.
• A dedicated jumper block can be modified to enable parallel wiring without making permanent changes to the rig.
• Schottky diodes should be installed in the jumper block rather than under battery plates to achieve the same effect.
• A modified parallel jumper block can handle multiple batteries in any configuration.
• The parallel jumper block can generate significant heat and may benefit from added cooling solutions.

Depends on

• This discussion applies specifically to CineLive systems.
• The modification approach using jumper blocks was recommended for flexibility but not independently verified in the thread.
• Heat management requirements for the modified block were mentioned but not detailed.
• The thread does not discuss specific diode specifications or wiring diagrams.

Gear in this thread

CineLivecatalog

Same gear or parts

1. 2025Compatibility of PRO camera plates between original D-Box and D-Box II top stagesCamera Stage/Donkey Box
2. 2025ALEXA 35 powering down when 24 V sled cable is disconnected or sled battery is swapped; voltage priority and status indicators.DisputedFacebookThe Steadicam Group
3. 2025Gimbal upgrade path for GPI PRO CineLive: Volt 2 now versus Volt 3 or alternative horizon stabilizers (Wave, MK-V Level), and adapter compatibility.DisputedFacebookThe Steadicam Group
4. 2025Organizing and transporting a Steadicam® kit in cases: storage, logistics, and rapid deployment.DisputedFacebookThe Steadicam Group