What the thread found

• The noise originates primarily from metal-to-metal contact between the Top Stage and the post, not from the stage itself.
• Cleaning the threads of the center post and stage, then tightening the four top screws and all screws around the post top provided only partial improvement.
• A small amount of white lithium grease applied between the Top Stage and post top surface resolved the noise for at least two operators.
• The post area where tilting moment is transmitted should be inspected carefully for damage before attempting other remedies.

Depends on

• Effectiveness may vary with the degree of wear, modification history, and load weight on the sled.

Parts

Top Stage

Same gear or parts

1. 2026Tightening a loose quick-release lever on the Top Stage dovetail plate, and preventing camera slip during shoulder operation.DisputedFacebookThe Steadicam Group
2. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rod mounts and CamJam mounts to minimize vibrationsDisputedSteadiHub
3. 2026Play in the sled: where it comes from and what can be fixed on the dayOperator practice
4. 2026Upgrading an older Steadicam® MK-V with 1.5-inch post to Volt configuration or switching to the new Steadicam® Elite (1.25-inch post, 14 kg).FacebookThe Steadicam Group