What the thread found

• The RED camera uses a Lemo 1B-310 connector with pin 1 as ground, pin 5 as record trigger input, and pin 8 as RS232 receive data.
• The Preston camera run connector is a Lemo 2B-312 with pin 1 as ground, pin 3 and 4 carrying the run signal at 30mA maximum, and pin 9 and 10 for RS232 communication.
• A direct pin-to-pin connection approach was suggested for interfacing the two systems, with ground pins aligned.

Depends on

• The discussion does not provide explicit confirmation of the correct complete wiring scheme between Preston and RED connectors.
• No information about voltage compatibility or current limitations when cross-connecting systems is detailed.
• This appears to be from 2009 and may not apply to current RED camera models.

Gear in this thread

MDR

Same gear or parts

1. 2026Power loss on Trinity 2 / Artemis 2 with large cameras (A35, Venice): causes and battery solutions.DisputedFacebookArri Artemis Trinity
2. 2025Custom servo zoom controller for Tilta Nucleus system using Bebob Zoe housing and 7-pin LEMO connectorFacebookSteadicam operators group
3. 2024Mounting Sony Venice 2 on ARRI Trinity with SAM-0 plate: build configuration and balancing strategies.FacebookArri Artemis Trinity
4. 2023Mounting Preston MDR4 focus motor and Light Ranger iris control on an ALEXA 35 on the ARRI TrinityFacebookArri Artemis Trinity