What the thread found

• A Hill Arri-3 Low-Mode Bracket can be used to mount a large cinema camera sideways.
• Multiple dogbone adapters attached to the XCS plate provide the rigidity and stability needed for a sideways-mounted camera setup.
• A sideways mounting approach using this bracket produced no vibration issues in field use.
• Monitor models with mounting points on all four sides simplify the challenge of mounting displays for sideways camera operations.
• Vertical frame composition using a 9:16 aspect ratio requires different compositional thinking compared to standard horizontal framing.

Depends on

• The setup described was improvised in a tight timeframe for an art installation project rather than a production environment.
• The feasibility of this approach within typical production schedules may be limited due to setup complexity.
• The experience was with a Varicam, not specifically a Phantom camera, though the principles may transfer.
• No detailed specifications are provided for optimal dogbone quantity or configuration.

Parts

Low Mode

Same gear or parts

1. 2026Choosing between Wave, Volt 2, and MK-V Level gimbals: performance in wind, rig weight, maintenance, and mode switching.DisputedFacebookSteadicam operators group
2. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rod mounts and CamJam mounts to minimize vibrationsDisputedSteadiHub
3. 2026Finding a bright (1500–2000 nits) low-mode monitor with recording and SDI I/O to replace a defective Transvideo Starlite.DisputedFacebookSteadicam operators group
4. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group