What the thread found

• Preston MDR2 receivers operate at 12 volts and can function on power supplies as low as 11 volts, drawing approximately 46.2 watts or 4.2 amps at full specification

Depends on

• Power draw specifications vary between Preston MDR1 and MDR2 models
• Current draw can spike to approximately 1 amp per motor when motors reach end stops during calibration
• D-tap socket output capacity varies depending on camera model and socket type
• Powering from camera D-tap on battery plate may create weight distribution issues for sled-mounted rigs
• Some users reported success while others expressed uncertainty about whether D-tap output capacity was sufficient

Gear in this thread

MDR

Parts

Follow Focus

Same gear or parts

1. 2026Power loss on Trinity 2 / Artemis 2 with large cameras (A35, Venice): causes and battery solutions.DisputedFacebookArri Artemis Trinity
2. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest workflow.FacebookSteadicam operators group
3. 2026Pulling focus and zoom yourself while operating, especially on live showsOperator practice
4. 2025Custom servo zoom controller for Tilta Nucleus system using Bebob Zoe housing and 7-pin LEMO connectorFacebookSteadicam operators group