What the thread found

• Any monitor equipped with a professional spigot connection can be mounted on a Cinetronic monitor yoke.
• A telescoping post bracket was being developed to accommodate Cinetronic Gen 1 or Gen 2 monitor yokes, with custom post sizing available at the time of order.
• The telescoping bracket for Cinetronic monitors was noted to be stiff and prone to accidentally engaging low-mode during operation.

Depends on

• The discussion from 2012 describes equipment under development with uncertain release timing.
• No successful Cinetronic II installation on an Archer 1 sled had been completed at the time of discussion.
• The Archer 1 yoke in this case was a custom-fabricated rig that might not accept standard professional spigot mounting solutions.

Parts

Low Mode

Same gear or parts

1. 2026Vest drops: what lowering the arm socket actually buys, and what it costs at the topOperator practice
2. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group
3. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rod mounts and CamJam mounts to minimize vibrationsDisputedSteadiHub
4. 2026Low mode and flipping the image: what to check on the camera before the dayOperator practice