What the thread found

• The bolts used on the Pro GPI docking collar and VZ gimbal can be tightened and loosened with a 5/32 inch Allen wrench.
• A 4mm Allen wrench can be used as an alternative if a 5/32 inch wrench is not available.

Depends on

• The information is based on assumption rather than confirmed specification for this particular component.
• This is from a 2009 discussion and may not apply to current equipment revisions.

Parts

Docking Ring

Same gear or parts

1. 2026Volt generations, and whether the system is necessary at allDisputedOperator practice
2. 2026EFP gimbal grip binding on the center rod: causes, cleaning, and repair versus replacement options.DisputedFacebookSteadicam operators group
3. 2023Recommended accessories and setup for the Tiffen M2 Volt gimbal systemFacebookSteadicam operators group
4. 2023Using a Hill docking collar beneath the blue ARRI docking collar on the carbon post of Artemis/Trinity.FacebookArri Artemis Trinity