What the thread found

• Vibrations during low mode operation are a recognized issue, particularly when running at fast pace
• Monitor arms with dual rods tend to introduce vibration in low mode more than in high mode operation
• Components including monitor arm brackets, camera power supply mounting, and lens mounts can become sources of vibration in low mode
• Tether lines run from the low mode camera plate up to the top of an inverted sled can be used under tension to counteract high frequency vibrations
• Repositioning the monitor arm to a normal low mode position or moving it to the outer post spreads mass distribution along the post length and can improve stability
• Vibration issues may not be visible during shooting but become apparent when reviewing dailies
• Reversing camera orientation can help reduce vibrations for certain shot types
• Grip assistance for repositioning the operator may help minimize vibration from running shots

Depends on

• The vibration reduction technique with tether lines has not been systematically tested across different rig configurations
• Multiple potential vibration sources exist and isolating the exact cause requires careful inspection of each component
• Low mode performance varies depending on specific top stage model and overall rig configuration
• Operator experience in low mode affects perception of stability issues

Gear in this thread

CineLivecatalog, MDR

Parts

Donkey Box, Low Mode

Same gear or parts

1. 2026Power loss on Trinity 2 / Artemis 2 with large cameras (A35, Venice): causes and battery solutions.DisputedFacebookArri Artemis Trinity
2. 2026Vest drops: what lowering the arm socket actually buys, and what it costs at the topOperator practice
3. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group
4. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rod mounts and CamJam mounts to minimize vibrationsDisputedSteadiHub