What the thread found

• Multiple MDR units positioned side by side can cause glitches and signal interference
• An interference reference table exists that maps which channels conflict with each other
• MDR channel numbering cycles, with channel 30 being identical to channel 0
• The HU-3 controller can display which channels are in use in the surrounding area to help identify interference sources
• Interference may originate from other wireless equipment operating nearby rather than from the MDR units themselves
• Moving away from the source of interfering signals resolves the problem
• Keeping a channel compatibility reference is useful for troubleshooting wireless interference on location

Depends on

• The reference table appears to only document channels 0 through 29
• The specific interference patterns may be model or firmware dependent
• One report describes intermittent problems during setup that resolved when moving away, but the exact cause was not definitively confirmed

Gear in this thread

HU3, MDR

Parts

Follow Focus

Same gear or parts

1. 2026Power loss on Trinity 2 / Artemis 2 with large cameras (A35, Venice): causes and battery solutions.DisputedFacebookArri Artemis Trinity
2. 2026Pulling focus and zoom yourself while operating, especially on live showsOperator practice
3. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest workflow.FacebookSteadicam operators group
4. 2025Custom servo zoom controller for Tilta Nucleus system using Bebob Zoe housing and 7-pin LEMO connectorFacebookSteadicam operators group