What the thread found

• The RED One camera power connector is a LEMO plug FGG.2B.306.CLAD 62 Z with pins 1 and 2 carrying +12V DC and pins 3 and 4 carrying ground, and both pairs should be used for reliable operation.
• Custom power cables can be successfully built to connect camera support equipment like Steadicam sleds and glidecam rigs to the RED One, allowing the camera to remain mounted in the carriage during battery swaps.
• When powering a RED One with hard drive from external sources, the camera can draw close to 6 amps at 14.4 volts, which may require using both the main power port and auxiliary port on supporting equipment.
• The RED One camera connector end uses standard LEMO plugs that are commercially available from electronics suppliers.
• A Y-cable configuration connecting both the main power port and auxiliary 12V power output allows hot-swapping batteries on camera support sleds without powering down the camera.
• Some RED One cameras have 6-pin connectors while others have 5-pin connectors at the camera end.

Depends on

• The claim about camera damage from non-official power sources was mentioned as hearsay without concrete technical explanation.
• Uncertainty exists about whether it is best to use only the main power port or both main and auxiliary ports when powering through PRO sleds.
• Some rental facilities refused to construct cables due to contradictory information they received from RED.

Gear in this thread

BFD

Same gear or parts

1. 2025History of wireless focus and lens control systems for Steadicam®: from cable-based Cinema Products and Seitz to Preston digital, and European solutions by Chrosziel, cmotion, and ARRI.FacebookSteadicam operators group
2. 2018Compatibility between analog Bartech follow focus handsets and digital motor systemsFollow Focus
3. 2018Identifying polarity of 2-pin Lemo power cables for BFD and Teradek unitsFollow Focus
4. 2016Payment collection challenges in equipment rental and cable supply servicesLegal / Business Practices