What the thread found

• The handle can be removed by taking out two screws at the front base where it connects to the camera body, one screw on the rear top of the handle with its associated plate, and two additional screws beneath that plate.
• Removing the handle exposes the tally lamp, which can remain in place or be taped down as needed.
• Handle removal allows the camera to fit into low mode cages or lens support rings that would otherwise not accommodate it.
• The handle can be reattached using only a single screw for low mode operation if needed for faster setup.

Depends on

• The procedure was discovered through hands-on experience rather than official documentation.
• Low mode operation with a single screw attachment was tested by only one participant and may require individual verification.

Parts

Low Mode

Same gear or parts

1. 2026Vest drops: what lowering the arm socket actually buys, and what it costs at the topOperator practice
2. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group
3. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rod mounts and CamJam mounts to minimize vibrationsDisputedSteadiHub
4. 2026Low mode and flipping the image: what to check on the camera before the dayOperator practice