What the thread found

• A single screw fastener is sufficient to safely mount a camera to a Steadicam top stage when using quality hardware and proper tightening technique
• The tensile strength of properly graded fasteners far exceeds the load requirements for camera mounting, with grade 8 fasteners providing approximately 80 percent higher shear strength than grade 2
• The primary concern with single-screw mounting is camera pivoting rather than fastener failure, as the screw tension bears the camera weight when correctly secured
• Historical precedent shows that large film cameras were hung from single screws without safety issues when appropriate hardware was used
• Fasteners purchased from camera equipment suppliers typically come with documentation certifying their intended use for camera mounting applications

Depends on

• The advice assumes correct fastener grade and proper installation technique
• Discussion references general fastener specifications without confirming what specific fasteners came with the mentioned rig model
• Cable tie safety precautions are mentioned only in the context of overhead jib use, not standard Steadicam operation

Gear in this thread

Zephyrcatalog

Parts

Top Stage

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group