What the thread found

• The Arri 435 with magazine, lens, focus motor, and receiver exceeds the 19-pound maximum capacity of a Flyer LE system
• An Arri LT camera at minimum setup weighs approximately 23.5 pounds, which is significantly over the 15-pound limit of a second-generation Flyer
• The Arri 435 proved too heavy when tested on a Zephyr rig
• An Arri 235 with a 200-foot magazine, prime lens, focus motor, clip-on matte box, and video transmitter can operate successfully on a Flyer LE system
• The weight of the sled itself must be included in the total weight calculation, which can cause the system to exceed its maximum capacity

Depends on

• Testing was conducted on Flyer LE and Zephyr systems with specific maximum weight ratings
• The Arri 235 configuration mentioned worked with a prime lens rather than a zoom lens, which adds weight
• No comprehensive specifications provided for all tested accessories and their individual weights

Gear in this thread

Zephyrcatalog

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group