What the thread found

• A universal mounting plate can be designed to accept multiple industry-standard mounts including RED V-Mount, IDX, Element Technica V-Wedge adapters, Wooden Camera A-Mount adapters, and Anton/Bauer connections.
• The plate can incorporate various threaded hole patterns such as 9mm on-center 1/4-20 holes (RED standard spacing), 1 inch on-center 10-32 tapped holes (Berkey System AKS), and 3/8-16 tapped holes to accommodate different accessories.
• Two plates can be screwed together with accessories clamped between them, enabling mounting of devices without built-in mounting points such as signal converters.
• Custom Anton/Bauer posts can be designed to attach to the plate with the ability to mirror or rotate them 180 degrees for flexible positioning.
• A modular plate design allows for future compatible accessories like power distribution units to be developed for use with the system.

Depends on

• The project was still in prototype phase at the time of discussion with a 3D printed version being tested.
• Production timeline and final specifications were not finalized during the forum discussion.
• Specific weight and material specifications were not detailed.
• Pricing and availability were not established.

Gear in this thread

Zephyrcatalog

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group