Connector pinouts for camera rig monitor and power cables

Gear

ZephyrCan I fly my Alexa or RED on a Zephyr?389

Master SeriesIs a used Master Series rig worth buying as a first big rig?191

BFDHow do I power my BFD receiver from my camera or sled?186

VoltCan I retrofit a Volt onto my existing sled or gimbal?168

ArtemisHow do I power my camera and accessories from an Artemis sled?166

MDRWhere can I mount my Preston MDR on my rig?143

ModulusIs there a Modulus option for HD wireless video?141

G-70Will my G-70 fit my vest, gimbal or sled?126

FI+ZCan I control iris and zoom wirelessly, not just focus?60

HU3Where can I get my HU3 repaired, refurbished or repainted?60

CineLiveHow do I pack and case my CineLive rig for transport?54

G-70XHow does the G-70X compare to Pro Titan, Xarm and other arms?46

Trinity 2Is Trinity 2 SUP 3.0 firmware safe to install or buggy?46

Ultra VestWhich vest should I choose for my body size, comfort and operator type?39

2006Monitors forum

20 years old. Gear and prices may have changed since.

PRO II Monitor Plug uses Lemo 1B308 connector with pin 1 as 12V ground, pin 2 as 12V power, pin 3 as video signal, pin 4 as video ground, pins 5-6 as not connected, pin 7 as level signal, and pin 8 as not connected.
PRO style Video/Power Out uses Lemo 0B304 connector with pin 1 as 12V ground, pin 2 as 12V power, pin 3 as video signal, and pin 4 as video ground.
Steadicam style 4-pin Hirose monitor connector uses pin 1 for power ground, pin 2 for video ground, pin 3 for video out/in, and pin 4 for power.
Monitor connectors are sled-specific and not universal across all manufacturers, though PRO style connectors have become widely adopted for compatibility.
Film camera power connectors vary by manufacturer: Arri 12-volt and Aaton models use 4-pin XLR wired for 12 volts, Moviecam uses 4-pin XLR wired for 24 volts, Arri 24-volt models use 2-pin Fischer connectors, and Panavision uses either 3-pin Lemo for older models or 2-pin Lemo for newer Millennium cameras.
Follow focus power cables and run cables are model and manufacturer specific and require matching connectors.

Information is from 2006 and may not reflect current equipment standards.
Pinouts are described for specific sled configurations and manufacturers; other manufacturers may use different standards.
No confirmation provided regarding whether these pinouts remain standard across equipment generations.