What the thread found

• The main cable connector on the Stanton Zoom Focus can become loose due to an internal locking nut that loosens over time.
• The unit can be opened by removing two small hex screws on the side that serve as tension screws, which allows the top piece to be pulled away while internal cabling remains partially attached.
• Once the top is lifted slightly, the internal locking nut can be shaken out, tightened, and reinstalled.
• Applying threadlocker compound to the locking nut after reassembly can prevent the nut from loosening again in the future.
• Disassembling the unit is considered difficult by the manufacturer due to internal complexity, but attempting the repair yourself is preferable to allowing the connector to fully disconnect, which could damage the circuit board connections and require soldering.
• The cable connector area should be handled carefully during disassembly to avoid damaging the internal wiring.

Depends on

• The exact procedure was recalled from memory rather than confirmed while the device was present, so minor details may be inaccurate.
• The manufacturer explicitly recommended against attempting this repair themselves and suggested sending the unit in for service.
• No confirmation was obtained that the repair was successfully completed and the unit functioned properly afterward.

Parts

Follow Focus

Same gear or parts

1. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest workflow.FacebookSteadicam operators group
2. 2026Pulling focus and zoom yourself while operating, especially on live showsOperator practice
3. 2025LC-1 (Lens Control-1) follow focus system: wired architecture, motors, and early operational experience (1990s).FacebookThe Steadicam Group
4. 2024Modifications to a Steadicam Scout rig for expanded power distribution and connectivityGeneral Discussion