What the thread found

• A monitor yoke bracket allows the display to tilt around its center of gravity without affecting the rig's balance.
• The yoke enables switching between normal and low mode operation without removing the monitor or flipping its image.
• The bracket frees up the original monitor mount point for use as an accessory mount.
• Manufacturing from ABS plastic via high-precision 3D printing provides durability and lightness while saving approximately 75 grams compared to original mounts.
• Removing the rear mounting plate improves heat dissipation from the monitor.
• Rosette connections provide solid positioning without vibration or slippage.
• The bracket is compatible with Marshall 7-inch monitors and can be adapted for different monitor widths using washers to accommodate size variations.
• The bracket functions on both Zephyr and Pilot rigs, though the Pilot has no grip as part of its gimbal design.
• Users report the yoke provides greater flexibility in monitor positioning relative to the rig while maintaining balance.

Depends on

• The bracket was initially battle-tested by a limited number of users before full release.
• Compatibility with monitors other than Marshall requires custom adaptation.
• Additional Marshall 1/4-inch adapters may be needed depending on existing equipment.
• The design was still undergoing final refinements at the time of this discussion.
• Testing was limited to specific monitor models mentioned in the thread.

Gear in this thread

Zephyrcatalog

Parts

Low Mode

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group