What the thread found

• The ARRI Trinity 2 can experience total shutdowns of the headbox, camera, and powerbox when radio transmitters are used in close proximity to the sled.
• Firmware version 1.5 on the Trinity 2 lacks the pan option on the main screen that is present in firmware 3.0.
• Older or cheaper batteries may not provide sufficient power for demanding setups and should be checked on the battery hanger display for power consumption; upgrading to a three-battery configuration can resolve power-related shutdowns.
• One operator initially attributed the issue to battery or power problems before identifying radio frequency interference as the actual cause.
• The problem occurred sporadically during standby but did not manifest during active shooting with adequate batteries.

Depends on

• Requires proximity of radio transmitters to the sled to trigger the issue.
• Battery-related shutdowns depend on setup power demands and battery quality.

Gear in this thread

Trinity 2catalog

Same gear or parts

1. 2026Buying strategy for a 25,000 USD entry-level rig: used Artemis-1 with Flowcine X-Arm versus Rever-Evo Sled, and the case for learning on budget equipment firstDisputedFacebookThe Steadicam Group
2. 2026Low-mode monitor selection for Volt Brain rig: latency performance of Transvideo Starlite versus current alternatives.DisputedFacebookThe Steadicam Group
3. 2026Trinity 2 tilt and roll drift in standard operation, and MGT-2 remote control connection causing pan and roll instability via LBUS.SteadiHub
4. 2026Mounting a Mo-Sys LED-wall tracking sensor on ARRI Trinity 2 with the sensor oriented upward for virtual production.FacebookArri Artemis Trinity