What the thread found

• A D bracket designed for low mode can be used in regular mode to lower the camera setup several inches without the arm bottoming out.
• The safety pin connection between the rig and D bracket is sufficient to hold the rig safely in this configuration.
• Heavy panning movements become difficult or impossible when using a D bracket in regular mode due to spatial interference between the bracket and other rig components.
• Rotating the D bracket section outward can prevent it from hitting monitors or gimbal parts during operation.
• This configuration, sometimes called Low High-mode, is useful for shooting at seated eye level heights.
• Mixing a 12 inch post on one side with a 3 inch post on the other allows quick lens height adjustment between 3 and 12 inches.
• Pre-drilled holes for safety pins may not be present on all gimbal handles, requiring custom machining in some cases.
• Safety pins must be made from quality steel with a minimum diameter of 4mm for adequate strength.
• Some brackets purchased from manufacturers come with safety pins included, eliminating the need for custom machining.
• Newer gimbal designs like ergonomic handles may not require inversion for low mode operation, making D bracket inversion unnecessary on those systems.

Depends on

• This technique restricts the camera's panning range and may not be suitable for shots requiring dynamic pan movements.
• Camera bottoming out concerns only apply to setups without D bracket use.
• Some gimbal handle designs lack pre-drilled safety pin holes, requiring custom fabrication.
• The configuration was not standard training material at workshops described in the thread.
• The technique's applicability depends on specific gimbal and bracket models available at the time of discussion.

Gear in this thread

Artemiscatalog

Parts

Low Mode

Same gear or parts

1. 2026Choosing between upgrading an older ProVid-2 kit or investing in a professional rig: workshop-first versus equipment-first approach for beginners.DisputedFacebookSteadicam operators group
2. 2026Buying strategy for a 25,000 USD entry-level rig: used Artemis-1 with Flowcine X-Arm versus Rever-Evo Sled, and the case for learning on budget equipment firstDisputedFacebookThe Steadicam Group
3. 2026MK-V Level horizon stabilizer: specifications, plate compatibility, price, and comparison to Wave.DisputedFacebookThe Steadicam Group
4. 2026Repairing shorted BNC video lines in an ARRI Artemis 1 sled: interim workarounds and permanent solutions.FacebookSteadicam operators group