What the thread found

• The Pro Vid 2 has a single-section arm that limits boom range compared to newer designs with two-section arms.
• The original 4x3 green-screen monitor on the Pro Vid 2 cannot be upgraded through the manufacturer.
• An external HD monitor can be added to the Pro Vid 2 by running video cable down the outside of the sled.
• Weight adjustment plates can be added to bring lighter cameras within the arm's operational range.
• The original green-screen monitor is extremely visible in daylight conditions, making it adequate for outdoor work.
• Purchasing one in good condition for a low price may still be worthwhile, but the rig has more compromises than current lower-end models.
• The gimbal smoothness varies between individual units and should be tested before purchase.

Depends on

• Limited discussion available online about this older model.
• Advice is based on individual user experience rather than comprehensive testing.
• No information provided about specific camera weight limits or payload capacity.
• The condition and performance of equipment that has been unused for 3-4 years was not evaluated.
• Socket block connector upgrade importance was mentioned as contested and not fully explained.

Gear in this thread

Zephyrcatalog

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group