What the thread found

• Some operators prefer locking the arm post to reduce the need for constant hand adjustment and to maintain stability during shots.
• Others operate with minimal or no friction on the arm post screw and report the gimbal handle staying in place without unwanted movement when the rig is properly balanced.
• Arm post friction preference may depend on operating stance and harness mounting orientation, with back-mounted setups experiencing different behavior than front-mounted rigs.
• Socket block balance and adjustment significantly influences whether the gimbal handle drifts when the arm post is loose.
• The gimbal arm's tendency to move when friction is released can indicate issues with the socket block balance, bent arm post, or bent wrist cap rather than requiring high friction.
• Running very loose arm post friction does not necessarily result in noticeable differences in shot quality for some operators.
• Longer gimbal arm lengths may make tight arm post friction more necessary for practical control during running shots.

Depends on

• No scientific study was presented to support either preference.
• Different rig configurations produce different results, making personal preference and setup-specific factors significant.
• The discussion involves multiple arm post designs and lengths, limiting universal applicability.
• Some claims about socket block behavior and balance remain unresolved between participants.

Gear in this thread

Zephyrcatalog, G-70catalog

Parts

Arm Post

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group