What the thread found

• The G70X arm can be used with multiple sled models by selecting the correct arm post adapter based on gimbal post diameter.
• For sleds with 5/8 inch diameter gimbal posts, the appropriate adapter is a 6 inch G70X arm post with 5/8 inch top connection.
• For sleds with 1/2 inch diameter gimbal posts, the appropriate adapter is a 6 inch G70X arm post with 1/2 inch top connection.
• Artemis and similar gimbals use 5/8 inch diameter posts, while Zephyr and similar gimbals use 1/2 inch diameter posts.

Depends on

• Information is from 2015 and may not reflect current product availability or pricing.
• Only addresses arm post adapter compatibility; other compatibility factors between the G70X arm and specific sleds are not discussed.

Gear in this thread

Artemiscatalog, Zephyrcatalog, G-70Xcatalog

Parts

Arm Post

Same gear or parts

1. 2026Why a 150 Wh battery at the sled powers the camera for only ~20 minutes versus two to three times longer when mounted on-body, and how to extend runtime.DisputedFacebookThe Steadicam Group
2. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
3. 2026Choosing between upgrading an older ProVid-2 kit or investing in a professional rig: workshop-first versus equipment-first approach for beginners.DisputedFacebookSteadicam operators group
4. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group