What the thread found

• A battery hanger for Zephyr that accommodates two 12/24V batteries enables hot-swapping power on RED cameras and distributes high current load between batteries
• RED Epic requires a different power cable than RED One, featuring a proprietary Lemo connector with a specific pin configuration
• The RED Epic power connector uses a 6-pin Lemo insert with 4 larger pins and 2 smaller pins, which differs from standard connectors available through electronics suppliers
• Custom RED Epic power cables can be fabricated by specialists and typically cost around $240
• The correct Lemo connector part for RED Epic can be ordered through local dealers if you know the specific part number

Depends on

• The discussion dates from 2011 when RED Epic was current technology
• Pricing information is from 2011 and may not reflect current costs
• One participant attempted to source a standard Lemo connector from an electronics supplier but found it had incorrect pin configuration

Gear in this thread

Zephyrcatalog

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group