2021Camera Stage/Donkey Box forum
Mounting a low mode monitor on Arri Artemis top stage
Note (as of October 2026)Curt O. Schaller, the developer of Artemis and Trinity, has no longer been with ARRI since the end of 2025. To our knowledge, ARRI currently has no dedicated team and no official contact persons for its stabilizer systems. In our view, the future of this line is uncertain. If you are buying new, get written confirmation from ARRI beforehand on how long service and spare parts are guaranteed. Have used rigs checked by the manufacturer before you buy.
What the thread found
- A monitor bracket can be attached to the Arri Artemis Follow Focus bracket as an alternative mounting solution.
- A low mode monitor mount designed for Artemis sleds uses 15mm rods and is described as providing stable mounting without vibration.
- The low mode monitor mount with 15mm rods is compatible with both Artemis 1 and Artemis 2 models.
Depends on
- The effectiveness of the Follow Focus bracket approach depends on having that specific bracket installed.
- The 15mm rod solution was recommended but detailed installation experience not extensively discussed.
Gear in this thread
Parts
Same gear or parts
- 2026Why a 150 Wh battery at the sled powers the camera for only ~20 minutes versus two to three times longer when mounted on-body, and how to extend runtime.DisputedFacebookThe Steadicam Group
- 2026Choosing between upgrading an older ProVid-2 kit or investing in a professional rig: workshop-first versus equipment-first approach for beginners.DisputedFacebookSteadicam operators group
- 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group
- 2026Voltage display discrepancies between camera and RCP on ARRI Artemis Trinity 2: 24 V rail showing 23.4 V at RCP versus 28 V at camera.DisputedFacebookArri Artemis Trinity