What the thread found

• Wire colors in Hirose cable assemblies are arbitrary and can be assigned to any pin at the connector, as long as the same correspondence is maintained at both ends of the cable.
• A common convention suggests using black for ground connections and red for positive voltage, though this is not a requirement.
• Pin function assignments for specific equipment models are documented in device manuals rather than determined by cable wire colors.

Depends on

• The discussion references a specific device model without providing the actual pin-to-color mapping for the mentioned cable.
• The response addresses general principles rather than providing a definitive color code for this specific connector type.

Gear in this thread

Zephyrcatalog

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group