What the thread found

• The Steadicam Axis is a new stabilization system combining gimbal-like ease with Steadicam precision through Volt electronically assisted stabilization on roll, tilt, and pan axes.
• The Axis features absolute encoding for the pan axis and does not require realignment of the sled after startup.
• The system supports camera payloads up to 20 pounds when used with the A-30 arm and vest.
• The Axis is designed to have faster setup times, wider range of motion, and easier learning curve compared to traditional gimbals.
• Free exhibition passes for NAB 2025 were available through early February 2025 using code ERA1.
• The Steadicam Axis appears to be the commercial product version based on a prototype demonstrated in 2023.

Depends on

• Payload capacity of 20 pounds is lower than the discontinued Zephyr model at 23 pounds.
• No information is available about whether the Volt technology will be offered as an upgrade for existing Steadicam Zephyr systems.
• Information about whether the Volt system will be designed or manufactured for older Steadicam models remains unknown.

Gear in this thread

Zephyrcatalog, Voltcatalog

Same gear or parts

1. 2026Compatibility and mounting options for Volt docking systems with alternative bracket solutionsWave/Volt
2. 2026Why a 150 Wh battery at the sled powers the camera for only ~20 minutes versus two to three times longer when mounted on-body, and how to extend runtime.DisputedFacebookThe Steadicam Group
3. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
4. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group