What the thread found

• The Decimator 2 accepts HD-SDI input and outputs HDMI and composite downconverted SD signals, so it cannot accept HDMI input directly.
• Custom cables to power the Decimator 2 typically cost between 50 and 80 dollars.
• One approach to powering the device is to cut off an existing AC adapter and solder a 4-pin XLR connector, using a multimeter to identify the hot and ground pins, which are pins 1 and 4.
• For soldering a custom power cable, one can repurpose existing connectors from underutilized cables to match the power input required by the device.
• When using a DSLR camera like the Canon 5D, 7D, or 60D with an SD composite monitor, the composite video output from the camera can be used directly rather than going through HDMI conversion.

Depends on

• The cost estimate of 50 to 80 dollars for a custom cable is anecdotal and may vary.
• The soldering approach requires technical skill and proper identification of power pins to avoid damage.
• Discussion mentions possible future changes to the Decimator power connector design, but no confirmation of implementation is provided.
• Compatibility with specific power regulators from different manufacturers requires matching voltage specifications, which may not be achievable with a simple cable alone.

Gear in this thread

Zephyrcatalog

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group