What the thread found

• Operating in heavy rain requires arm covers, rain covers for cameras, clear bags, and saran wrap to protect monitors and lower portions of equipment
• Wind conditions present challenges that cannot be fully mitigated without proper equipment like quality grips or gyroscopic stabilizers
• Layered clothing and safety gear make operating more difficult physically
• The PRO arm design with enclosed spring cartridges and drawbars rather than extension springs and cables reduces the need for rain protection compared to other stabilizer designs
• Extended exposure to cold and wind at high altitudes can pose serious health risks to crew members

Depends on

• No practical training method was identified for preparing operators for real adverse weather conditions before actual shoots
• Rain covers that accommodate wireless audio receivers and mattebox attachments are difficult to source and may appear improvised
• The specific altitude and wind speed conditions mentioned were extreme cases from a particular Las Vegas location
• The discussion did not reach consensus on whether formal adverse weather training is feasible or commonly practiced

Gear in this thread

MDR

Same gear or parts

1. 2026Power loss on Trinity 2 / Artemis 2 with large cameras (A35, Venice): causes and battery solutions.DisputedFacebookArri Artemis Trinity
2. 2025Custom servo zoom controller for Tilta Nucleus system using Bebob Zoe housing and 7-pin LEMO connectorFacebookSteadicam operators group
3. 2024Mounting Sony Venice 2 on ARRI Trinity with SAM-0 plate: build configuration and balancing strategies.FacebookArri Artemis Trinity
4. 2023Balancing and shortening a Steadicam® rig with a heavy zoom lens (14–15 lbs).FacebookThe Steadicam Group