What the thread found

• The XL2 with mini35 adapter combination is approximately 1.5 pounds heavier than a DVX100a with mini35 adapter, which already maxes out a Flyer system
• Flying the XL2 with mini35 setup on a Flyer is possible but requires holding the arm up to level and places excessive stress on the vest
• Removing the camera's original viewfinder, mattebox, and studio follow focus system significantly reduces weight
• Using a compact clip-on mattebox and single focus motor instead of full studio rigging helps achieve acceptable weight
• A shortened baseplate segment from a damaged rental unit can replace the full plate to further reduce weight
• The XL2 adapter ring is smaller than the Panasonic equivalent since it does not need to accommodate a 72mm front end, potentially making the XL2 setup lighter than a DVX100a combination
• Removing the camera viewfinder is typically unnecessary during aerial operation

Depends on

• The weight reduction method involving a shortened baseplate requires sourcing damaged rental equipment and custom drilling
• The shortened baseplate approach resulted in damage during one actual use, limiting its practical reliability
• Testing of XL2 with mini35 on Flyer was not completed at time of discussion, only DVX100a testing was confirmed
• The feasibility depends on adding counterweight to the bottom of the system

Parts

Dovetail Plate, Follow Focus, Base Plate

Same gear or parts

1. 2026Operating a Steadicam® Zephyr without Volt: drop time, horizon control, and the effect of upper-rig weight distribution on balance.DisputedFacebookSteadicam operators group
2. 2026Eliminating vibration with the ARRI ALEXA 35 on Steadicam®: rigid mounting plate options to bypass the dovetail systemFacebookThe Steadicam Group
3. 2026Swapping the camera between tripod and rig: the cheapest upgrade most operators never makeOperator practice
4. 2026Pulling focus and zoom yourself while operating, especially on live showsOperator practice