What the thread found

• The Dock n Roll is an add-on accessory that mounts onto Jerry Hill docking brackets and allows the Steadicam rig to be tilted and rotated while remaining locked to a docking stand, useful for maintaining specific framings during lighting setups or multi-camera coordination.
• The device uses Teflon bearings which assist in quickly assessing rig balance during assembly, particularly beneficial for complex beam-splitter three-dimensional camera rigs with multiple cameras.
• Installation requires only 1/8 inch and 1/4 inch Allen wrenches and reuses the original mounting screws, with assembly taking approximately 90 seconds to 10 minutes.
• The accessory is compatible with Jerry Hill docking brackets sold by both Jerry Hill and Tiffen.
• Users report the device eliminates the need to switch to a tripod for static shots or remove the rig from the stand when framing adjustments are needed during location work.

Depends on

• The device adds only 0.5 inches or less in total length when attached.
• Some users noted the lock-down mechanism tightness may need adjustment to prevent unwanted slippage during use.
• The price of 350 Euros plus shipping was noted as high for users in non-European currencies.

Parts

Docking Bracket

Same gear or parts

1. 2026Compatibility and mounting options for Volt docking systems with alternative bracket solutionsWave/Volt
2. 2026Volt generations, and whether the system is necessary at allDisputedOperator practice
3. 2025Dynamic balance drift after removing dock from sled, caused by loose hardware on modular connector stages.SteadiHub
4. 2025Organizing and transporting a Steadicam® kit in cases: storage, logistics, and rapid deployment.DisputedFacebookThe Steadicam Group