What the thread found

• A small vertical shift of 1-2mm in the gimbal pan bearing when switching to low-mode can occur in the M2 gimbal.
• Tiffen confirmed that this type of play in the pan bearing is considered within normal tolerances.
• Multiple operators have reported experiencing similar play in their M2 gimbals.
• The vertical play does not cause operational problems when the gimbal is under load during flight.

Depends on

• Only reported on Tiffen M2 models.
• The manufacturer did not provide a technical fix or adjustment procedure.
• The extent of play may vary between individual units.

Parts

Gimbal Bearing, Low Mode

Same gear or parts

1. 2026Lubricating a Steadicam gimbal bearing after cleaning, and the Tri-Flow supply problemOperator practice
2. 2026Vest drops: what lowering the arm socket actually buys, and what it costs at the topOperator practice
3. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group
4. 2026The pan bearing in the gimbal: what a Kaydon bearing is, what fails, and what a change of supplier would and would not meanOperator practice