What the thread found

• The ARRI Trinity 2 can be operated remotely via an RF radio module that enables wireless L-Bus connection.
• A complete wireless remote setup requires the RF module set, a joystick controller (EJS-1), and optional wheel controller (DRW-1).
• The joystick or wheel controller can be powered through the L-Bus connection itself, eliminating separate power requirements.
• Multiple component combinations exist for remote control setups, similar to modular assembly systems.
• The DP operates tilt and roll control via the joystick mounted on a tripod or table.

Depends on

• Specific power requirements depend on the L-Bus configuration and connected load.
• Setup options vary based on whether joystick or wheel control is preferred.

Gear in this thread

DRW-1catalog, Trinity 2catalog

Same gear or parts

1. 2026Buying strategy for a 25,000 USD entry-level rig: used Artemis-1 with Flowcine X-Arm versus Rever-Evo Sled, and the case for learning on budget equipment firstDisputedFacebookThe Steadicam Group
2. 2026Mounting a Mo-Sys LED-wall tracking sensor on ARRI Trinity 2 with the sensor oriented upward for virtual production.FacebookArri Artemis Trinity
3. 2026Low-mode monitor selection for Volt Brain rig: latency performance of Transvideo Starlite versus current alternatives.DisputedFacebookThe Steadicam Group
4. 2026Trinity 2 tilt and roll drift in standard operation, and MGT-2 remote control connection causing pan and roll instability via LBUS.SteadiHub