What the thread found

• Dynamic balance should be achieved first without cables connected, then cables should be added afterwards without adjusting the rig base
• After adding cables, rebalancing should be done only through topstage and gimbal adjustments, leaving the rig base unchanged
• Horizon drift during panning is typically caused by base offset rather than dynamic balance issues
• Dynamic balance primarily affects the tilt axis during panning movements

Depends on

• Applies specifically to setups using SMPTE cables for studio camera operations
• The horizon leveling problem described may stem from different causes than dynamic balance
• The response was provided while the questioner was on set with limited time for detailed explanation

Gear in this thread

Zephyrcatalog

Parts

Top Stage

Same gear or parts

1. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
2. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
3. 2026First stabilizer purchase: Steadicam® Elite (14 kg payload, integrated Volt 3) versus Rever Evo (higher payload) and used-market strategy.DisputedFacebookThe Steadicam Group
4. 2026Removing a stuck aircraft pin from a used Steadicam® Zephyr arm connection block and reconfiguring to goofy modeFacebookSteadicam operators group