What the thread found

• The standard docking bracket on a Flyer support is too short to allow 360-degree rotation of the camera for database checking
• Rotating a camera 360 degrees while mounted on a Flyer support is not technically necessary for database verification, though it may be convenient
• Extending a bracket by cantilevering the camera further away from a lightweight aluminum Flyer stand can create stability problems due to the increased weight moment

Depends on

• The discussion involves an older camera support model from 2007
• No custom bracket solution was documented or tested in this thread
• The specific weight and balance characteristics depend on the particular Flyer stand model and camera being used

Parts

Docking Bracket

Same gear or parts

1. 2026Volt generations, and whether the system is necessary at allDisputedOperator practice
2. 2026Compatibility and mounting options for Volt docking systems with alternative bracket solutionsWave/Volt
3. 2025Organizing and transporting a Steadicam® kit in cases: storage, logistics, and rapid deployment.DisputedFacebookThe Steadicam Group
4. 2025Dynamic balance drift after removing dock from sled, caused by loose hardware on modular connector stages.SteadiHub