What the thread found

• Vibrations in a Zephyr gimbal setup can be addressed by adding a stiffening system rather than replacing the baseplate
• Vectran rigging can reduce vibrations but requires creative attachment since the Zephyr lacks standard vectran mounting points
• Using a Zalex baseplate combined with 15mm rod brackets creates a rigid connection that eliminates vibrations
• SmallRig's super lightweight 15mm railblock is an inexpensive option suitable for stabilizing camera rigs

Depends on

• The Zephyr gimbal does not have factory vectran attachment points
• The effectiveness of the Zalex and rod bracket solution is reported by a single user
• Vectran attachment method on Zephyr was not fully documented in this discussion

Gear in this thread

Zephyrcatalog

Parts

Base Plate

Same gear or parts

1. 2026Tightening a loose quick-release lever on the Top Stage dovetail plate, and preventing camera slip during shoulder operation.DisputedFacebookThe Steadicam Group
2. 2026Discontinuation of Steadicam® Aero 30 and Axis entry-level rigs, availability of service and spare parts for discontinued models, and purchasing strategy alternatives.DisputedFacebookThe Steadicam Group
3. 2026Used Zephyr with original SD monitor shows 'No signal' with Sony FX6; HD-SDI compatibility and monitor upgrade.FacebookSteadicam operators group
4. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group