What the thread found

• BMS battery bricks lack the voltage converter normally included on Artemis 2, requiring battery plates to match the voltage needed by each device.
• For 12v camera cables, a single 12v battery source (V-Mount, Gold Mount, or 12v B-Mount plate) can power camera, monitor, and accessories through BMS bricks.
• For 24v camera cables, two battery plates are required: one 24v plate (Gold Mount 26v or B-Mount 24v) for the camera and one 12v plate (V-Mount, Gold Mount 12v, or 12v B-Mount) for monitor and accessories.
• Alternatively, a single 24v B-Mount plate with a P-TAP to LEMO cable can supply both 24v to the camera and 12v to other devices.
• One BMS brick model (K2.0052057) supports hot-swapping batteries.
• ARRI supplies P-TAP to LEMO cables to derive 12v power from 24v B-Mount battery plates, bypassing the plate output if needed.

Depends on

• System design depends on camera voltage specification (12v or 24v input).
• Battery plate compatibility varies by type (V-Mount, Gold Mount, or B-Mount) and voltage rating.
• Solution requires matching cable types to battery plate outputs.

Gear in this thread

Artemiscatalog

Same gear or parts

1. 2026Buying strategy for a 25,000 USD entry-level rig: used Artemis-1 with Flowcine X-Arm versus Rever-Evo Sled, and the case for learning on budget equipment firstDisputedFacebookThe Steadicam Group
2. 2026Repairing shorted BNC video lines in an ARRI Artemis 1 sled: interim workarounds and permanent solutions.FacebookSteadicam operators group
3. 2026Lemo connectors on the ARRI Artemis sled: pinout, polarity verification, and powering low-mode monitors and Volt battery.FacebookSteadicam operators group
4. 2026Upgrading an M1 Volt gimbal from 1.5-inch to 1.75-inch center rod: insert replacement procedure and encoder ring considerations.DisputedFacebookSteadicam operators group