What the thread found

• A stabilized gimbal can be mounted directly to the top of a camera sled post, bypassing the x/y stage, to maintain rigidity and center alignment.
• A small monitor mounted on the gimbal handle allows the operator to see the shot at all times when the main monitor is not visible due to camera angles.
• A joystick controller on the gimbal handle provides tilt control.
• The gimbal must bolt directly to the post rather than to an x/y stage, which may limit compatibility with certain sled types.
• Counterweights for the gimbal were designed to be simple and compact.

Depends on

• Compatibility with sled types that use x/y stages as the top mounting surface remains unclear.
• Mounting a monitor on the gimbal handle presents practical concerns including weight, operator proximity, cable management, and maintaining proper frame alignment during pans.
• The account of technical specifications comes from a secondhand recollection during informal circumstances.

Gear in this thread

Artemiscatalog

Same gear or parts

1. 2026Repairing shorted BNC video lines in an ARRI Artemis 1 sled: interim workarounds and permanent solutions.FacebookSteadicam operators group
2. 2026Upgrading an M1 Volt gimbal from 1.5-inch to 1.75-inch center rod: insert replacement procedure and encoder ring considerations.DisputedFacebookSteadicam operators group
3. 2026Powering camera, monitor, and accessories simultaneously on ARRI Artemis with BMS battery bricks and matching battery plates.SteadiHub
4. 2026Evaluating whether to repair an older ProVid 2 system or invest in a newer rig for entry-level steadicam workSteadi-Newbies